Wuxi Huizhou Fishery Machinery Co.

Professional designed machinery focusing on feed/biomass pelleting area with reassuring after-sales service.

Home > Knowledge > Content
Modular feed pellet mill use method
- Sep 30, 2018 -

When the modular feed pellet mill is put into use, it is first necessary to make the new machine run-in. Usually you can take 3 to 10 pounds of mixed powdered feed, add 10% edible oil and mix thoroughly, and open the oil block by hand, first add the feed, start the machine and adjust the pressure roller bolt with a wrench until the normal discharge. The oily feed is repeatedly squeezed 3-5 times in the machine, and then gradually added dry material.

 

Note that when the new machine Modular feed pellet mill is run-in, it does not need to be run-in later. After adding the dry material, if you hear the mechanical boring, you should loosen the pressure roller bolt a little and release it normally. If the oiled material is not pressed out, or the dry material is placed, the pellet machine does not discharge, and the steel nail is used to expose the feed in the mold plate (the steel nail is flattened), and then re-run.

 

In the production process of the Modular feed pellet mill, if the length requirements of the feed granules are different, the length of the granules can be adjusted by adjusting the cutter provided on the side of the discharge opening. Note that the prepared pellets have a relatively high temperature and should be placed in a ventilated place and stored in a bag when cooled to room temperature.http://www.bio-pelletmill.com/