Wuxi Huizhou Fishery Machinery Co.

Professional designed machinery focusing on feed/biomass pelleting area with reassuring after-sales service.

Home > Knowledge > Content
Maintenance requirements and parking inspection of livestock feed pellet mills
- Nov 24, 2018 -

In the process of maintenance, the livestock feed pellet mill bears the full load of the machine, so there will be a good relationship between the bearing and the bearing life, because it directly affects the use of the equipment. Life and operation rate, therefore, the required lubricant must be cleaned, the seal must be good, the main oil filling part of the machine (1) rotating bearing (2) roll bearing (3) all gears (4) movable bearing, sliding plane.

Livestock feed pellet mills need to pay attention to the normal operation of all parts of the equipment. Check the wear level of some wear parts when using, pay attention to replace the worn parts, put the chassis plane of the movable device, should go out Dust and other things to prevent the movable bearing from moving on the chassis when the machine encounters materials that cannot be broken, resulting in serious accidents.

If the rotating gear of the livestock feed pellet mill is in operation, it should immediately stop and check, and then eliminate the installation test. The equipment should be installed on the concrete foundation of the love level and fixed with anchor bolts. When installing, pay attention to the vertical direction of the main body and the horizontal. After installation, check if the bolts in all parts are loose and the main door is tight. If necessary, tighten them.

https://www.bio-pelletmill.com/